Televes 769501 - Page 70

70
GPON ONT
5.6.2.3.1 GRE Tunnel Setting – Basic Conguration Mode
In the basic conguration mode only Tunnel Name and Remote IP are required for setting the GRE Tunnel, Figure 5-56. Remote IP is the Public
IP address of the routing device terminating the GRE Tunnel in the other extreme of the tunnel (Refs. 769501-769502 of network B in the shown
example), Figure 5-53.
Figure 5-56: WAN Service setup window - GRE Tunneling Settings – Basic conguration mode
After entering the required information, use Next button to progress to the next window, WAN Service setup window- GRE Tunneling Settings –
GRE Summary, Figure 5-57. This table should reect the conguration for the GRE-Tunnel service setup parameters than have been congured.
Please verify the presented conguration match the settings provided by the ISP for this service.
Figure 5-57: WAN Service setup window- GRE Tunneling Settings – GRE Summary
To nalize the conguration use the Save/Apply button, Figure 5-57. The next displayed window is initial window, the WAN Service Window, where
the service congured is displayed in the corresponding table, Figure 5-58.