Teleview TAV900A - CONFIG;RF-IN1 Sub-Menu; CONFIG;RF-IN2 Sub-Menu

TLV-300E/TAV-900A Professional Digital TV Receiver User’s Manual
3.2.4 CONFIG/RF-IN1 sub-menu
To configure RF related modes. There are RF-IN1 and RF-IN2 sub-menu.
Table 17 CONFIG/RF-IN1 submenu architecture
CONFIG
RF-IN1 Configure RF input-1 source.
RF-IN1/ TUNE CENTER
FREQ
Switch MAIN channel source into RF input-1 and Tune by
center frequency value.
RF-IN1/TUNE CH Switch MAIN channel source into RF input-1 and Tune by
channel selection.
RF-IN1/FREQUENCY
PLAN
Select channel plan. Mode can be TERRESTRIAL, STANDARD
CABLE, HRC CABLE, or IRC CABLE.
RF-IN1/MODULATION Select Modulation type: 8VSB, 64QAM, 256QAM.
RF-IN1/BER INTERVAL Select BER calculation interval.
RF-IN1/EQUALIZER ON / OFF the channel equalizer of the demodulator. ON is
strongly recommended.
3.2.5 CONFIG/RF-IN2 sub-menu
The sub-menus are as same as RF-IN1 sub-menus.
Table 18 CONFIG/RF-IN2 submenu architecture
CONFIG
RF-IN2 Configure RF-IN2 input source.
RF-IN2/TUNE CENTER
FREQ
Switch SUB channel source into RF-IN2 and Tune by center
frequency value.
RF-IN2/TUNE CH Switch SUB channel source into RF-IN2 and Tune by channel
selection.
Version 2.0 36