TLV-300E/TAV-900A Professional Digital TV Receiver User’s Manual
Table of Contents
1. OVERVIEW 7
1.1 Introduction 7
1.2 Delivered Contents 8
1.3 Front Panel Overview 8
1.3.1 Alphanumeric Display 10
1.3.2 Function Buttons 11
1.3.3 Numeric Buttons 12
1.4 Rear Panel Overview 13
1.4.1 Overview 13
1.4.2 Video Output 14
1.4.3 Audio Output 15
1.4.4 Digital Output BNC Connectors (AES3/DVB-ASI/SMPTE-310M) 15
1.4.5 DVB-ASI/SMPTE-310M Input BNC Connectors 16
1.4.6 RF Input Connectors 16
1.4.7 Communication Port 16
1.4.8 FAULT Output Port 16
1.4.9 Power Switch & Inlet 16
1.5 BNC Configuration 17
2. GETTING STARTED 18
2.1 Initial Hook-up 18
2.2 Verifying YPbPr or RGB Component Video Output (Only if applicable display is attached) 19
2.3 Verifying SDI Video Output (Only if applicable display is connected) 19
2.4 Verifying Composite Video Output (Only if applicable display is connected) 22
2.5 Verifying 8VSB Digital TV Signal Decoding thru RF Input (Only if you have 8VSB RF input available)
22
2.6 Verifying Digital TV Signal Decoding thru DVB-ASI or SMPTE-310M Input (Only if you have this
source available) 23
2.7 Verifying QAM Digital TV Signal Decoding thru Cable TV Input (Only if you have Digital Cable RF
input available) 24
2.8 Verifying Analog Audio Output 25
2.9 Using DVB-ASI or SMPTE-310M TS Output 25
2.10 Using Digital Audio Output 25
Version 2.0 2
To Next Page
Loading...
