/:
Rev A: 0611
5/98
"
TEMPTRONIC
v
CF"3PbTON
SAFETY
PRECAUTIONS
A.
Safety Precautions For Operating Personnel
TP04100A Interface
&
Applications
Symbols:
A.
Caution,
B.
High Voltage,
C.
Hot Surface,
D.
Cold Surface
&'i
NO
l,Oi
7
Preventive Maintenance
Symbol
WARNING
1:
Operating personnel should perfom only the procedures described and recommended in this
manual. Only qualified service personnel familiar with the electrical shock hazards present inside the
equipment should perform disassembly or corrective maintenance of the equipment.
WARNING
2:
To avoid shock hazard, the equipment must be grounded with an adequate earth ground in
accordance with local electrical codes.
WARNING
3:
The locations of potentially dangerous voltages and other hazards such as hot surfaces are
identified and labeled on the equipment. Be careful to observe these warnings when installing, operating,
maintaining, or servicing the equipment. Observe all warnings given in this manual.
WARNING
4:
Make sure to turn off the
-
(ac) line power and the compressed air to the TP04100A System
before attempting to access or service the air filters. Do not perform this service unless qualified to do so.
WARNING
5:
Exposed surfaces in and around the output nozzle and thermal cap of the system can operate
at extremely hot and cold temperatures which are unsafe to touch.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
