Tenda O6 - Web UI Login; Login Procedure

Web UI login
- 11 -
3 Web UI login
3.1 Login
When using the device for the first time, you can log in to its web UI via a browser with default login information.
The default login information includes:
Item
Default Setting
IP Address
192.168.2.1
Username and Password
admin
To log in to this device:
(Assume that the AP is in factory default state and ensure that your PC is connected to the device.)
1. Set your PC’s IP address to 192.168.2.X (2~254).
>> Method 1: Set your PC to Obtain an IP address automatically.
>> Method 2: Manually set your PC to 192.168.2.X (2~254), with a subnet mask of 255.255.255.0. (If the
switch and AP are in the same IP segment, make sure that the switch, AP and PC have different IP addresses).
For detailed steps, see Appendix Configure your computer.
Tip
The AP’s DHCP server is enabled by default. Once you finished settings on Quick Setup page, the DHCP server
will be disabled automatically.
Or