Tenda O6 - Ping Watch Dog

Web UI Functions
-56-
Parameter description:
Parameter
Description
SNMP
Enable/Disable the AP SNMP agent function. The default is Disable.
Device Name
AP device name. The default is O6V1.0.
Read
Community
Select a read operation password between SNMP management software and SNMP agent. The
default is public.
This SNMP agent allows SNMP management software to perform the read operation on
variables in AP MIB using Read Community.
Read/Write
Community
Select a read and write operation command between SNMP management software and SNMP
agent. The default is private. This SNMP agent allows SNMP management software to perform
the read and write operation on variables in AP MIB using Read/Write Community.
Location
AP installation location. The default is ShenZhen.
Ping Watch Dog
The Ping Watch Dog function is a function that the AP detects network connectivity. After ping packets are sent
periodically to a destination IP address, if a reply is normally received, it indicates that the network is unobstructed.
If no response is obtained within Maximum Discard Packets, the AP will automatically reboot. After reboot, it will
continue to detect until the network is restored to normal.