Terex Genie GS-1330m User Manual

August 2021 Service and Repair Manual
Scissor Components
Part No. 1309020GT GS
™
-30m • 32m • 30 • 32 • 46 • 55 139
9-11
Scissor Arm Wear Pads
How to R e place the S cis sor Ar m W e ar P a d - GS -1432m , G S- 1932 m, GS-1932m Lite, G S-1 932 m XH
How to Replace the Scissor Arm
Wear Pad - GS-1432m, GS-1932m,
GS-1932m Lite, GS-1932m XH
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both ground and platform controls.
2 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
3 Raise the safety arm from the drive chassis to
a vertical position.
4 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
5 At the ground controls, turn the key switch to
the off position and push in the red
Emergency Stop button to the off position.
6 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
7 Remove the fasteners securing the platform
height sensor cover to the chassis.
8 Remove the platform height sensor cover.
9 Tag and disconnect the platform height
sensor from the platform height sensor
harness.
10 Remove the fasteners securing the platform
height sensor short arm cover to the number
1 inner arm.
11 Remove the fasteners securing the platform
height sensor to the chassis. Remove the
sensor.
12 Connect the battery pack to the machine.
13 Turn the key switch to ground controls.
14 Press and hold the ground control scroll up
and scroll down buttons.
15 Pull out the red Emergency Stop button to the
on position at the ground controls.
16 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
17 Raise the platform and rotate the safety arm
to the stowed position.
18 Fully lower the platform to the stowed
position.
19 Remove the platform. Refer to Repair
Procedure, How to Remove the Platform.
20 Remove the pins, shims and snap rings from
the number 1 inner arm at the steer end of the
machine.
21 Attach a lifting strap from an overhead
supporting device to the steer end of scissor
assembly.
Crushing hazard. The scissor
assembly will fall
if not properly
supported when removed from
the drive chassis.
22 Replace the wear pads.

Terex Genie GS-1330m Specifications

General

Brand	Terex
Model	Genie GS-1330m
Category	Lifting Systems
Language	English