Terex Genie GS-1330m User Manual

Service and Repair Manual August 2021
Manifolds
52 GS
™
-30m • 32m • 30 • 32 • 46 • 55 Part No. 1309020GT
5-6
Function Manifold Components – Models with hydraulic drive,
GS-1530, GS-1532, GS-1930, GS-1932, GS-1932 XH
The function manifold is mounted under the machine, between the module trays.
Index No. Description
Schematic
Item
Function Torque
—
Coil nut
F
—
4-5 ft-lbs / 5-7 Nm
—
Coil nut
E, H —
5-7 ft-lbs / 7-9 Nm
1
Diagnostic port
A Test port —
2
Check disc
B Steer circuit
18 ft-
lbs / 24 Nm
3
Relief valve, 180
0 to 3700 psi / 124 to
25
5 bar
C Lift relief
20 ft-
lbs / 27 Nm
4
Check valve, 1
0 psi / 0,7 bar D Drive circuit
20 ft-
lbs / 27 Nm
5
Solenoid valve,
3 position 4 way E
Drive
forward/reverse
25 ft-
lbs / 34 Nm
6
Solenoid valve, 3 position 4 way
F
Steer left/right
25 ft-
lbs / 34 Nm
7
Flow regulator and relief valve,
0.7
5 gpm / 2,8 L/min, 1500 psi / 130 bar
G
Steer circuit
26 ft-
lbs / 35 Nm
8
Solenoid valve,
2 position 4 way H Platform up
25 ft-
lbs / 34 Nm
9
Relief valve, 370
0 psi / 255 bar I System relief
20 ft-
lbs / 27 Nm
How to Install a Valve Cartridge
1 Dip the cartridge in clean oil to lube the O-rings.
2 Screw the cartridge in by hand until the top O-ring is met, then torque to specifications.
3 If required, install the valve coil(s) onto the valve stem. Install the coil nut onto the valve stem and
torque to specifications.

Terex Genie GS-1330m Specifications

General

Brand	Terex
Model	Genie GS-1330m
Category	Lifting Systems
Language	English