TESTO 400 - Page 117

13 testo DataControl PC software
117
Via the first tab Characteristics and the field Display properties, you
can change the clothing and activity parameters in the next window.
This recalculates the PMV/PPD values and also the graphic. In order
to
be able to compare different calculations/graphics with each other, you
need to save the respective CSV and PDF files. The calculations are
overwritten in each case - it is therefore not possible to view different
results of a measurement at the same time.
13.8.3 Table view
In the Table tab, all the measurement parameters and the corresponding
measuring values for each point in time of the measurement, depending on the
measuring cycle, are displayed. All measuring values can be viewed using the
mouse wheel, the arrow keys on the keyboard or the scroll bars in the footer or
at the right-hand margin.
At the bottom of the table are the average and min/max values of the
measurement for all measurement parameters. The individual measurement
parameters to be displayed in the table can be selected via the icon . This
choice also has an effect on the ducts available for selection in the Graphic view
(see Section 13.8.2). Only the measurement parameters visible in the table can
be selected there.