14 Performing an Experiment
• Strip Chart (Optional): Strip Chart continuously collects samples
but only retains the last x data points collected. (“x” represents
the number of points defined in the Number of Points field.)
•
Data Marker (Optional): Selecting this option places the Add Data
Marker in the Data collection controls area.
Click the Add Data Marker icon to emphasize specific points, such
as when you observe a change or when you change a condition.
Some examples of change are:
– Ice begins to form.
– You stir the solution.
– You add a chemical to the solution.
6. Click OK.
The settings are saved for the next run.
Setting the Events with Entry Collection Mode
Use the Events with Entry collection to capture samples manually by
defining the independent value for each point you collect.
To set the collection mode as Events with Entry:
1. Click Experiment > Collection Mode > Events with Entry.
The Events with Entry Setup dialog box opens.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
