Thames Side Smart Series - ADD (Add); CONTROL (Cntl); PORT (Port)

Configuration and Calibration
3-11
3.4.8 CONTROL (cntl)
Control of the hardware flow (RTS signal of the RS-232-C protocol)
These are the options:
OFF: Deactivated function
ON: Activated function
3.4.9 PORT (port)
Port selection enabled. If “RS-232” is selected, the ADD parameter is forced to be “0”.
3.4.10 ADD (add)
Address of the equipment in a RS-485 network. It has to be “0” to operate as a RS-232
port.