Thames Side Smart Series - BAND (Band); BAUD (Baud); DELAY (Del); FORMAT (For)

Configuration and Calibration
3-13
3.5.1. MODE(type)
Transmission mode.
These are the options:
OFF (off): Data transmission deactivated
STREAM (st): Continuous data transmission
TICKET (ti): Transmission on a print internal request (Print key)
AUTO (auto): It is automatically transmitted on acomplishing the condition for
automatic operations on ports (see 2.11). The transmission
format is the one specified in Format (see 3.5.3)
AUTO TICKET (autoti): A ticket is automatically printed on acomplishing the º
condition for automatic operations on ports (see 2.11).
AUTO TOTAL (autoto): Totalizes automatically on acomplishing the condition
for automatic operations on ports (see 2.11).
3.5.2. BAND (band)
Only accessible if the options AUTO, AUTO TICKET and AUTO TOTAL are activated
in the MODE parameter.
It is the numerical value which determines the band of performance for the options
AUTO, AUTO TICKET and AUTO TOTAL of the MODE parameter.
3.5.3. FORMAT (for)
Format of transmitted data for STREAM.
These are the options:
F1, F2, F3, F4, F5, F6, F7, F8, F9, F10, F11, F12, F13 (see 2.10)
3.5.4. BAUD (baud)
Transmission speed.
These are the options:
4800, 9600, 19200
3.5.5. PARITY (par)
Number of data bits and parity.
These are the options:
8-none: 8 bits data
7-even: 7 bits data, 1 bit even parity (even)
7-odd: 7 bits data, 1 bit odd parity (odd)
3.5.6. DELAY (del)
It is the delay time from the request to the data transmission. If configured in STREAM
mode, it is the delay time between the transmitted data.
These are the options:
OFF, 250ms, 500ms, 1s, 2s
3.5.7. TERMINATION (ter)
Termination of the data blocks.
These are the options: