THERA-Trainer BEMO - Troubleshooting; Clear T.assist signal; Clear error

EN User manual THERA-Trainer bemo
21
Article no. A007-661_Rev 2.0 - Last edited: 2020-06-02
10.5. Troubleshooting
10.5.1. Clear T.assist signal
 Follow signal clearance instructions.
‒ Status light is orange.
‒ Beeps sound.
T.assist code
Signal clearance
A002
Rear distance detection is triggered.
– Distance detection responds during training when an obstacle enters the detection zone.
 Increase distance.
 To continue exercising see chapter 17.3.3.
A003
Front distance detection triggered.
– Distance detection responds before and during training when an obstacle enters the
detection zone.
 Increase distance.
 To continue exercising see chapter 17.3.3.
10.5.2. Clear error
 Follow troubleshooting instructions.
‒ See Appendix I (error code).
‒ If T.assist is available, status lights are orange and beeps sound.
 Confirm error codes by pressing the STOP button.
‒ Only possible if error has been cleared or no longer exists.
10.6. Disposal
To dispose of the THERA-Trainer:
 Note country-specific regulations and specifications.
 Dispose of metal parts as scrap metal.
 Dispose of plastic parts according to the type of material.
 Dispose of electric and electronic components as electronic scrap.
11. Adjustment options
11.1. Height of THERA-Trainer bemo
Adjust height of the THERA-Trainer via electric lifting columns.
 Press the lifting column height control buttons (see chapter 18.1.2).
‒ Make sure that no body parts are pinched when the height of the lifting column is lowered.
‒ If distance detection responds, the height adjustment process of the THERA-Trainer stops
(see chapter 17.3.3).