THERA-Trainer BEMO - Change History

User manual THERA-Trainer bemo EN
50
Article no. A007-661_Rev 2.0 - Last edited: 2020-06-02
Error code
Troubleshooting
E645
 Contact trained supplier.
 Perform system configuration.
E651
 Contact trained supplier.
 Check foot chapter sensor.
E652
 Contact trained supplier.
 Check distance detection sensor.
E660
Different approved accessories plugged in.
 Make sure that it is not a foot rest and an adapter for upper body training that are plugged in.
E661
Automatic detection of radius of movement or accessory options faulty.
 Contact trained supplier.
E662
Automatic detection of accessory options on the right faulty.
 Contact trained supplier.
E663
Automatic detection of accessory options on the left faulty.
 Contact trained supplier.
E664
Automatic detection of accessory options on the right/left faulty.
 Contact trained supplier.
E676 / E677 /
E678 / E679 /
E680 / E681
The THERA-Trainer detects over- or under-voltage.
 Start training only when the THERA-Trainer has been started via the START button.
If error message occurs repeatedly:
 Contact trained supplier.
Change history
Version of user
manual
Change
1.0
Initial version
2.0
Inclusion of following content:
- Emission and immunity tables.
- Use of dummy plug for patient emergency stop.
- Note on incorrect symmetry display.
- Driving force changed to 2 Nm.