THERA-Trainer BEMO - Patient emergency stop; T.assist signal

User manual THERA-Trainer bemo EN
34
Article no. A007-661_Rev 2.0 - Last edited: 2020-06-02
Compatibility check for beds/couches with shock position feature:
 Make sure that a training session with the THERA-Trainer and bed/couch is possible.
‒ Collision with the THERA-Trainer during shock position:
o
Distance detection responds. Training is possible.
o
Distance detection does not respond. Training should only be carried out under supervision.
17.3.4. Patient emergency stop
WARNING!
Risk of injury if patient emergency stop is missing!
 Exercise only under supervision if there is no patient emergency stop.
 Ensure that the patient emergency stop and/or bed bell can be reached by the patient at all times during
training.
The patient emergency stop is an external button for the patient to immediately terminate a training
session. Ensure that the patient emergency stop can be reached throughout the entire training session.
 Press patient emergency stop in dangerous situations.
‒ The number of revolutions and the exercising resistance slow down to 0 immediately.
‒ The display unit shows STOP.
‒ If T.assist is available, the status light flashes orange and beeps sound.
To exit emergency stop:
 Press STOP button.
17.3.5. T.assist signal
WARNING!
Risk of injury due to defective T.assist signal!
Only train under supervision if T.assist signal is detected as defective during boot-up:
 Make sure that status indicators light up in the colours blue, red and green every time you start up the device.
 Make sure that beeps sound every time you start up the device.
 Have malfunctions repaired by trained suppliers.
WARNING!
Risk of injury due to missing T.assist!
 Only use the THERA-Trainer without T.assist for training under supervision.
 Only train shock-prone patients under supervision if T.assist is not available.
For unsupervised training, make sure that the patient emergency stop and/or bed bell can be reached
at all times.
The volume of the different signal tones is identical and can be adjusted over 10 levels (53 - 62 dB(A))
by trained specialists. Factory setting = Level 10 (62 dB(A))
The T.assist signal helps to quickly detect dangerous situations. States of the status light:
‒ Orange – the THERA-Trainer is not ready for operation
o Emergency stop button is pressed (see chapter 17.3.1)
o Distance detection responds (see chapter 17.3.3)
o Patient emergency stop pressed (see Chapter 17.3.4)
‒ Green – the THERA-Trainer is ready for operation or being used for training