THERA-Trainer BEMO - Safety equipment

User manual THERA-Trainer bemo EN
32
Article no. A007-661_Rev 2.0 - Last edited: 2020-06-02
17.3. Safety equipment
WARNING!
Risk of injury due to damaged safety equipment!
 Before every training session, make sure that safety equipment is working correctly.
 Have malfunctions repaired by trained suppliers.
17.3.1. Emergency stop button
 In hazardous situations, press the emergency stop button on the control and display unit.
‒ The number of revolutions and the exercising resistance slow down to 0 immediately.
‒ The display unit shows STOP.
‒ If T.assist is available, the status light flashes orange and beeps sound.
To exit emergency stop:
 Press START button.
- OR -
 Disconnect power plug.
 Wait 5 seconds.
 Connect power plug.
 Press the START button to start the new training session.
If the THERA-Trainer immediately starts with the training session after you press the START button:
 Press emergency stop button.
‒ Contact trained supplier and notify them about the defect.
‒ Do not use the THERA-Trainer for further training sessions.
17.3.2. Spasm detection
Possible causes for triggering of spasm detection:
‒ Detected spasm
‒ Irregular pedalling
‒ Uncontrollable muscular activity
‒ Set motor power exceeded
After spasm detection is triggered:
‒ The THERA-Trainer stops the power supply to the cranks.
‒ Cranks are freely movable.
‒ The control and display unit displays spasticity symbol (see chapter 18.1.3).
‒ After 5 seconds, the THERA-Trainer restarts at a speed reduced by 5 rpm.
o
Set the direction of movement in the submenu after a spasm has been detected (see chapter 18.2).
If spasm detection responds repeatedly:
‒ Stop training session.
‒ If necessary, set the sensitivity for spasm detection in the submenu (see chapter 18.2).
‒ If necessary, reduce the radius of movement (see chapter 11.3).
‒ If necessary, increase/decrease revolutions per minute (see chapter 18.1.2).
‒ If necessary, increase drive power (see chapter 18.2).