User manual THERA-Trainer bemo EN
12
Article no. A007-661_Rev 2.0 - Last edited: 2020-06-02
Note
After shipping, leave the THERA-Trainer at room temperature for 1 hour before using it for the first time.
Surface temperatures of the THERA-Trainer may increase/decrease due to external heat or cold sources
(e.g. sunlight, outdoor environment).
Make sure that the THERA-Trainer is protected from penetrating liquids.
Only use the THERA-Trainer in approved environmental conditions.
Only use the manufacturer’s original parts.
Only use accessories approved by the manufacturer.
Only exercise with the THERA-Trainer, if the THERA-Trainer is switched on and was started with the
START button.
Make sure that the THERA-Trainer or the bed/couch/chair/wheelchair do not slip while exercising.
Only use the power cable supplied by the manufacturer.
Only use cleaning agents and disinfectants approved by the manufacturer.
Use only mains fuses in accordance with chapter 8.
6. Instruction
Read and follow the user manual.
The instruction should be carried out by specialists trained by the manufacturer.
An assistant should be instructed by specialists trained by the manufacturer.
THERA-Trainer assumes no liability for damage caused in connection with a training session carried
out by untrained specialists.
7. Warranty
The manufacturer’s warranty, which complies with the statutory provisions, applies. The basis is the date of
delivery.
Within this period of time, the manufacturer will replace free of charge any faulty parts of the THERA-Trainer
or repair free of charge the THERA-Trainer in the factory or an authorised workshop.
The following are excluded from the manufacturer’s guarantee:
‒ Wear parts
‒ Opened devices
‒ Third-party installations and attachments
‒ Devices repaired by persons other than trained suppliers.
‒ Any damage due to incorrect use.
‒ Any damage caused by insufficient packaging.
To Next Page
Loading...