Receiver Descrambler - User Manual (release 7.3.1)
1.1 Installation
Cooling
The unit is cooled via forced induction through the front of the unit and exhausted through the vents on
either side. The unit is equipped with a temperature controlled status indicator. If the temperature in the
inside of the unit exceeds 70° C the red “Error” LED will illuminate and a description of the error will appear
in the “Error List.”
Rack Information
The unit is intended to be mounted in a standard 19” rack. It occupies 1RU of rack space and the
connections are all on the rear of the unit.
Rack Installation
To install the unit into a rack use the following steps:
1. Determine the desired position in the rack for the unit making sure that the
air intake on the front of the unit and the exhausts on the sides of the unit
will not be obstructed.
2. Insert the rack mount clips into place over the mounting holes in the rack.
3. Slide the unit into position in the rack.
4. Secure the unit to the rack by installing the four supplied screws through the
front mounting holes and tightening.
To Next Page
Loading...
