THOMSON RD1000 - 4.5 Dual Input COFDM Receiver Configuration

THOMSON RD1000 / RD1002
Page 33
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
4.5 Dual Input COFDM Receiver – Option NRD00H04AA
General Information
Install Location: Any slot except 1-1 or 2-1.
I/O: (2) 75 Female F Connectors
Supported Formats: COFDM
Description: This card will allow the unit to receive a COFDM signal for use in electronic news gathering
(U.S.) or any COFDM Terrestrial Broadcast (DVB-T, European) applications. Only one input may be
selected at a time.
To Edit the Option Card Input Settings
To edit this input card, use the following steps:
1. Press the button.
Note: For dual units, select RDS1 or RDS2, then press .
2. Use the and buttons to select “Input Modules”, and
press the button.
3. Use the and buttons to move the cursor to “Dual
COFDM” card of the specific slot (e.g. 1-4). Notice the location
diagram in the upper right corner of the screen changes as
the cursor moves by each card.
4. Press the button once to display the Status screen for
the COFDM card.
5. Press the button again to display the Edit screen for the
COFDM card.
Source
This option will select which input, on the back of the card, will be active.
 Input 
Dual QPSK 1-3
►Dual COFDM 1-4
 Input 
Active Input
Backup Mode
►Input Modules
 Input 
►Active Input
Backup Mode
Input Modules