Receiver Descrambler - User Manual (release 7.3.1)
5.3 Configuration
5.3.1 Input Setup
To set the desired input as active use the following steps:
1. Click on the or tab of the corresponding RDS that needs to be configured.
Note: In a single unit, there will only be a tab.
2. Click the button on the same line as
the input you wish to make active.
Note: The input is already active if the button looks like this:
3. A dialog box will appear asking “Are you sure
you want to change the active input?” Click
to approve the action.
4. Once the desired input had been set to active, the
specific options of that input card can be set by
clicking on the icon next to the active input. When
the icon is clicked, an edit window will appear with
the specific options for that card. Use the drop down
menus and input boxes to complete the edit form.
Click the button at the bottom of the form to
save the settings. The current settings for any of the
input cards can be verified by clicking on the button
next to the desired input.
To Next Page
Loading...
