Receiver Descrambler - User Manual (release 7.3.1)
1. Use the and buttons to move the cursor to “LNB
Power:” then press the button.
2. Use the and buttons to select “Off”, “13VDC” or
“14VDC” for vertical polarization, “18VDC”or “19VDC” for
horizontal polarization, then press the button to save the
selection.
22 kHz Tone
22 kHz Tone is configurable separately for each Source input, but is only supplied to the active source. The
22 kHz Control Tone setting is either on or off.
Note: The 22 kHz Tone is only sent if the is LNB Power being supplied – the LNB Power is not set to “off”.
1. Use the and buttons to select “Off”, “13VDC”,
“14VDC”, “18VDC”, “19VDC”, then press the button to
save the selection.
2. Use the and buttons to move the cursor to “22 kHz
Tone:” then press the button.
Tuning Frequency
The DVB-S/S2 card tunes by the L-band frequency rather than the transponder frequency or local oscillator
value. The L-band frequency is the difference between the downlink transponder frequency “Sat Freq:” and
the LNB local oscillator frequency “LO Offset:”. The IRD will calculate the actual frequency in which the
card tunes; saving the user time and possible miscalculation errors.
Local Oscillator Offset
The Local Oscillator Offset provides preset values that can be selected using the List mode. Any valid
Local Oscillator Offset value can be entered using the Manual mode.
1. Use the and buttons to move the cursor to “LO
Offset Mode:” then press the button.
2. Use the and buttons to select “Man” (for manual)
or “List”, then press the button to save the selection.
3. When in “List” mode, use the and buttons to
move the cursor to “LO Offset:”, then press the
button.
4. Use the and buttons to select “00000MHz”,
05150MHz”, 09750MHz”, “10600MHz”, “10750MHz” or
“11250MHz” as the “LO Offset” setting, then press the
button to save the setting.
DVB-S/S2 1-4
LO Offset Mode:List
►LO Offset:00000MHz
Sat Freq:00950 Mhz
DVB-S/S2 1-4
►LO Offset Mode:Man
LO Offset:00000MHz
Sat Freq:00950 Mhz
DVB-S/S2 1-4
DVB Mode:DVB-S2
►LNB Power:Off
22kHz Tone:off
DVB-S/S2 1-4
DVB Mode:DVB-S2
►LNB Power:Off
22kHz Tone:off