THOMSON RD1000 - 4.2 8 VSB;QAM Receiver Configuration

THOMSON RD1000 / RD1002
Page 27
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
4.2 8VSB/QAM Receiver – Option NRD00HCSAA
General Information
Install Location: Any slot except 1-1 and 2-1.
I/O: (1) 75 Female F Connector
Supported Formats: 8VSB, QAM64B, QAM256B
Description: This card provides demodulation of 8VSB or QAM. For 8VSB the card is able to tune to
channels 2-69 on UHF/VHF and channels 2-134 on the cable channel bands of FCC cable, IRC, and
HRC. For QAM, the card is able to receive both QAM64B and QAM256B and is able to tune to
channels 2-134 in the cable bands of FCC cable, IRC, and HRC.
To Edit the Option Card Input Settings
To edit this input card, use the following steps:
1. Press the button.
Note: For dual units, select RDS1 or RDS2, then press .
2. Use the and buttons to select “Input Modules”, and
press the button.
3. Use the and buttons to move the cursor to the
“VSB/QAM” card of the specific slot (e.g. 1-4). Notice the
location diagram in the upper right corner of the screen
changes as the cursor moves by each card.
4. Press the button once to display the Status screen for
the VSB/QAM card.
5. Press the button again to display the Edit screen for the
VSB/QAM card.
 Input 
ASI/310M 1-2
MPEG/IP 2-3
►VSB/QAM 1-4
 Input 
Active Input
Backup Mode
►Input Modules