Receiver Descrambler - User Manual (release 7.3.1)
The CAM interface bitrate is limited to 72Mbps. It receives the total incoming TS, not only the scrambled
services.
Caution: Some input interfaces could provide more than 72Mbps, thus preventing correct decryption.
This option also enables BISS mode 1 & E descryption. It manages one key per channel, means one key for a
single configuration and two keys for a dual configuration.
3.7 Dual MPEG over IP Input/ UDP Output – Option NRD00H05AA
This card is a dual purpose card in that it can receive and/or transmit from the internal TS bus, MPEG over IP.
It has two physical connectors that can be configured independently. Up to two multicasts can be subscribed
to, allowing for a backup multicast to be chosen and two UDP mirrored unicasts can be transmitted to allow for
redundancy
Example Configurations: IP Address Selection
“Leave” IGMP V2 & V3 Multicast/Unicast Unicast: X.X.X.X – 223.255.255.255
Filter Mode: Include Multicast: 224.X.X.X – 239.255.255.255
IP list: empty Suggested Multicast Range: 239.192.X.X
“Join” IGMP V2 & V3 Multicast/Unicast Suggested Port Selection
Filter Mode: Exclude - Choose a port number of 5000 or more
IP list: empty - Choose even numbered ports
- If using FEC the following example applies
“Join Filtered” IGMP V3 Multicast/Unicast - Destination port = 5000
Filter Mode: Include - Column FEC = 5002
IP: X.X.X.X - Row REC = 5004
Or - Next available multicast port = 5006
Filter Mode: Exclude
IP: X.X.X.X
3.8 Advanced Satellite Features – Option NRD00S02AA
This software option enable the Advanced Satellite Features of the NRD00H12AB (DVB-S/DVB-S2 Quad port
receiver optional card).
If the NRD00S02AA option is installed, the”Multistream” settings will be available and the NRD00H12AB card
will be able to receive multistream transport streams, VCM, 16APSK modulation and 32APSK modulation.
To Next Page
Loading...
