THOMSON RD1000 - Lnb Power

Page 38
THOMSON RD1000 / RD1002
Edition 2 – October 2010
Receiver Descrambler - User Manual (release 7.3.1)
Multistream Mode
When “Multistream” is disabled (or not licensed), the card will not be able to receive multistream inputs.
The card will identify the input error as a multistream input.
1. Use the and buttons to move the cursor to
“Multistream:” then press the button.
2. Use the and buttons to select either (“Off”, “On”),
then press the button to save the selection.
ISI
Note: The setting of the “ISI” is only available when the “Multistream Mode” is set to “On”.
1. Use the and buttons to move the cursor to “ISI
Mode:” then press the button.
2. Use the and buttons to select either (“Manual”,
“List”), then press the button to save the selection.
Available ISI
The selection of ISI values are from the ones available within the multistream input.
1. Use the and buttons to select an ISI that is
available in the multistream input, then press the
button to save the selection.
Manual ISI
The ISI value is entered independent of the ISI values present in the input multistream. This is used
when the Source is being configured without the source being the active input.
1. Use the and buttons to select the column to
edit and use the and buttons to change the
ISI value (0 – 255), then press the button to save
the selection.
LNB Power
LNB power is configurable separately for each Source input, but is only supplied to the active source.
In addition, the power is used to transmit the polarization to the LNB.
 DVB-S/S2 1-4 
Multistream:Enabled
ISI Mode:Manual
►ISI:17
 DVB-S/S2 1-4 
Multistream:Enabled
ISI Mode:Manual
►ISI:17
 DVB-S/S2 1-4 
Multistream:Enabled
►ISI Mode:Manual
ISI:17
 DVB-S/S2 1-4 
DVB Mode:DVB-S2
►Multistream:Disabled
LNB Power:Off