THOMSON RD1000 - Source Settings; Selecting the Source

THOMSON RD1000 / RD1002
Page 37
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
Source
This option will select which input, on the back of the card, will be active.
1. Use the and buttons to move the cursor to “Source
Select:” then press the button.
2. Use the and buttons to select which input to be
active (“A”, “B”, “C”, “D”), then press the button to save
the selection.
Source Settings
These settings correspond to the “Source” input that is selected. Repeat these steps for each input source,
“Source A”, “Source B”, “Source C” and “Source D”.
Selecting the Source
The DVB-S/S2 card can receive either DVB-S or DVB-S2 transmission.
1. Use the and buttons to move the cursor to the
Source (“Source A” , “Source B”, “Source C”, “Source D”) to
edit the settings, then press the button.
DVB Mode
The DVB-S/S2 card can receive either DVB-S or DVB-S2 transmission.
1. Use the and buttons to move the cursor to “DVB
Mode:” then press the button.
2. Use the and buttons to select either (“DVB-S”,
“DVB-S2”), then press the button to save the selection.
Enabling Advanced DVB-S2 Capabilities
The NRD00H12AB option card can support Multistream input, VCM, 16APSK and 32APSK Modulation.
These advanced capabilities are enabled with an “Advanced Satellite Features” license, see Section 4.16
and 5.11. The license is enabled by entering a License Key and the status of the License is noted in the
License “Feature List”. The license enables the “Advanced Satellite Features” capabilities for all
NRD00H12AB option cards in the unit.
When licensed, the “Multistream” settings will be available and the NRD00H12AB option card will be able
to receive multistream transport streams, VCM, 16APSK modulation and 32APSK modulation.
 DVB-S/S2 1-4 
►DVB Mode:DVB-S2
Multistream:Disabled
LNB Power:Off
 DVB-S/S2 1-4 
Source Select:A
►Source A
Source B
 DVB-S/S2 1-4 
►Source Select:A
Source A
Source B