THOMSON RD1000 - Event Logging

THOMSON RD1000 / RD1002
Page 83
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
5.4.2 Event Logging
Just below the “Active Errors” is the “Event Logging” section. This section shows all the possible events
that the unit will log. Follow the steps below to either enable or disable an event.
1. Click the button under the “Event Logging” heading. This will
bring up a new edit form in the middle of the screen.
2. Choose either the “General, Video, Audio, DPI, or System” tab
to enable or disable events under those headings.
3. Then click the button, at the bottom of the form, to
save the settings.
5.4.3 Unit Date/Time
The next section is the “Unit Date/Time” section. This section gives an overview of how to configure the
date and time of the unit.
1. Click the button under the “Unit Date/Time” heading.
This will bring up a new edit form in the middle of the
screen.
2. Use the drop down menu to select either “Auto, or
Manual.”
3. If “Auto” is selected, the option to use a time server is
available. Enter the IP address of the Time Server in the
space provided.
4. Then click the button to save the changes.