THOMSON RD1000 - 4.1 Input Option - Active Input and Backup Configuration Selection

Page 24
THOMSON RD1000 / RD1002
Edition 2 – October 2010
Receiver Descrambler - User Manual (release 7.3.1)
4.1 Input Option – Active Input and Backup Configuration Selection
General Information
The selection of the Active input and configuration of the Backup input are described in this section.
Supported Option Cards: NRD00HCSAA (8VSB Input interface), NRD00H02AA (ASI Input/Output),
NRD00H04AA (COFDM Input) and NRD00H05AA (MPEG over IP Input/Output).
Description: The Active input specifies the card that is being used as the input option. The Backup
configuration enables/disables the switching to a backup input, defines the Primary Input and Backup
Input, when to restore to the Primary Input and a timeout before switching to the Backup Input or
restoring to the Primary Input.
Changing the Active Input
To set an Active Input, use the following steps:
1. Press the button.
Note: For dual units, select RDS1 or RDS2, then press .
2. Press the button to edit the Active Input. The current
Active Input is displayed along with a “(P)” for Primary or “(B)”
for Backup if the Backup Mode in enabled.
3. Press the button again to edit the Active Input.
4. Press the button again to use the and buttons
to change the Active Input selection, then press the
button to save the selection.
 Input 
Active Input:
► ASI/310M 2-3 (P)
 Active Input 
Active Input:
ASI/310M 2-3 (P)
 Input 
►Active Input
Backup Mode
Input Modules