THOMSON RD1000 - Page 25

THOMSON RD1000 / RD1002
Page 25
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
Note: When Backup Mode is enabled, only the Primary or Backup input option
can be made the active input. If Backup Mode is disabled, any installed input
option can be made the active input.
Configuring Input Backup Settings
1. Press the button.
2. Use the and buttons to move the cursor to “Backup
Mode”, then press the button.
3. Press the button again to edit the Backup settings.
Setting the Backup Mode
1. Use the and buttons to move the cursor to
“Backup:”, then press the button.
2. Use the and buttons to select “Enabled” or
Disabled” and then press the button to save the
selection.
Setting the Primary Input
1. Use the and buttons to move the cursor to the
input shown as the Primary Input, then press the
button.
2. Use the and buttons to select the input option to
use as the Primary and then press the button to save
the selection.
Setting the Backup Input
1. Use the and buttons to move the cursor to the
input shown as the Backup Input, then press the
button.
2. Use the and buttons to select the input option to
use as the Backup and then press the button to save
the selection.
 Backup Mode 
ASI/310M 1-2
Backup Input:
► MPEG/IP 1-3
 Backup Mode 
Backup:Enabled
Primary Input:
► ASI/310M 1-2
 Backup Mode 
►Backup:Enabled
Primary Input:
ASI/310M 1-2
 Input 
Active Input
►Backup Mode
Input Modules