THOMSON RD1000 - Appendix C - Specifications; Appendix C.a. Device - Base Unit

THOMSON RD1000 / RD1002
Page 99
Receiver Descrambler - User Manual (release 7.3.1)
Edition 2 – October 2010
Appendix C – Specifications
Appendix C.a. Device – base unit
ROHS Compliant
Yes
Includes:
Display, keypad, embedded controller, Chassis/case, Power
Supply/line cord
System –
Display type:
VFD (Vacuum Fluorescent Display)
Display Configuration:
4 lines x 20 characters
Keypad:
Membrane switches
Front Panel Lockout:
Password control, up to 10 alpha-numeric characters (no
punctuations or spaces allowed
Configurations Allowed:
Single channel configuration – 8-Slot
Dual channels configuration – 4-Slot
Rear panel:
Eight available slots
Six I/O interface slots
Two video output slots (one per channel)
Remote Operation/Update Interface –
Type:
Ethernet, 10/100
Rear panel indicators:
Link (Green LED), Activity (Amber LED)
Connector:
RJ45
Serial Remote operation interface –
Type:
RS232
Protocol:
115, 8, N, 1
Connector:
9-pin D-sub, male
Front Panel Indicators –
Input LED:
Green indicates valid input on selected input
Off indicated no valid signal on the selected input
Constant Blinking Green for dual units indicates one valid input
and one invalid input
Error LED:
Red indicates error is occurring
Off indicated no errors detected
AC Power –
Operating Voltage:
95–135 VAC or 180–265 VAC
Max Power:
200 W
Current Draw/Power:
Typical 1 Receiver with 4 option cards:
0.40 A / 50 W
Typical 2 Receivers with 8 option cards:
0.60 A / 70 W
Frequency:
47–63 Hz
Connector:
IEC C14
Line Cord:
Detachable, 6 foot, 3-prong
DC Power –
Operating Voltage:
40 – 60 VDC
Max Current Draw/Power:
4.17 A / 200 W (at 48 VDC)
Current Draw/Power:
Typical 1 Receiver with 4 option cards:
1.04 A / 50 W
Typical 2 Receivers with 8 option cards:
1.46 A / 70 W
Connector:
Tyco Amplimite 109 series 3C3
Line Cord:
Detachable, 5 ½ foot