THOMSON RD1000 - Page 34

Page 34
THOMSON RD1000 / RD1002
Edition 2 – October 2010
Receiver Descrambler - User Manual (release 7.3.1)
1. Use the and buttons to move the cursor to “Source:”
then press the button.
2. Use the and buttons to select which input to be
active (“A”, “B”), then press the button to save the
selection.
Input A
These settings correspond to the input on “Source A.”
Center Frequency A
The COFDM card tunes to the center frequency of the channel to tune to.
1. Use the and buttons to move the cursor to
“Center Freq:” then press the button.
2. Use the and buttons to select the column to edit
and use the and buttons to change the center
frequency (49 MHz – 861 MHz), then press the
button to save the selection.
Channel Bandwidth A
1. Use the and buttons to move the cursor to
“Channel BW:” then press the button.
2. Use the and buttons to change the channel
bandwidth (“6 MHz”, “7 MHz”, “8 MHz”), then press the
button to save the selection.
Spectrum A
1. Use the and buttons to move the cursor to
“Spectrum:” then press the button.
2. Use the and buttons to change the spectrum
(“Normal”, “Inverted”), then press the button to save
the selection.
Input B
These settings correspond to the input on “Source B.”
Center Frequency B
The COFDM card tunes to the center frequency of the channel to tune to.
 Dual COFDM 1-4
Center Freq:049MHz
Channel BW:8 MHz
► Spectrum:Normal
 Dual COFDM 1-4
Input A
Center Freq:050MHz
► Channel BW:8 MHz
 Dual COFDM 1-4
Input A
► Center Freq:050MHz
Channel BW:8 MHz
 Dual COFDM 1-4
►Source:A
Input A
Center Preq:049MHz