2-8
dummyheaddummyhead
SERVICE INFORMATION
TOOLS
COMMERCIALLY AVAILABLE TOOLS
ORDERING INFORMATION
These tools are distinguished by the words (Commercially available). They are not available through the American Honda Parts
Development. Most commercially available tools shown in this Shop Manual can be ordered through the Honda Marine Tool and
Equipment Program by calling (888) 424-6857. Refer to the catalog for a complete tool listing.
SPECIAL TOOLS
They are available through the American Honda Parts Department and ordered by using normal American Honda Parts ordering
procedures.
Tool name Tool number Application
Valve seat cutter, #115 30° NWY-CU607
Valve seat reconditioning
Valve seat cutter, #122 45° NWY-CU608
Valve seat cutter, #111 60° NWY-CU270
Solid pilot bar, 5.5 mm NWY-140-5.5
T-wrench, #505 NWY-TW505
Accessory package, #246 NWY-KACC246
Digital multimeter FLU-88 Idle speed/electrical testing
Engine oil pressure gauge kit
Engine oil pressure gauge
MT37A
MT37AH
Cylinder leak oil pressure testing/inspection
Leak down tester KLIAT1006M Cylinder leak down
Compression gauge EEPV303A Cylinder compression testing
Puller, 2 jaw
– Pins (2 required)
– Pressure screw
–Jaws
–Tip
–Yoke
see below
CJ-105-11
CJ-105-3
CJ105-6
CJ-66-15-3
CJ-86-1
Prop shaft holding during backlash inspection
Gear case filler
Adapter, 8 x 1.25 mm
STV-S33
STV-3334Y
Gear case filling
Pressure tester
Adapter, 8 x 1.25 mm
STV-V34
STV-3334Y
Gear case pressure check
Clamps HCP6 Water Separator removal/installation
Piston ring compressor RC40C Piston installation
Valve lapper LIL-21100 Valve lapping
Torque angle gauge TA360 Cylinder head torquing
O
2 sensor wrench ANM14 HO2S removal/installation
Heat gun ETB1600 Lower center housing removal/installation
Driver, 480 mm
070GD-001A100
Ring gear holder
070PB-ZY3A100
Bearing race puller
070PC-ZY3A101
To Next Page
