3-3
dummyheaddummyhead
MAINTENANCE
*1: Cylinder sleeve water jacket
*2: Exhaust manifold
*3: Cylinder block
1. Lubricate more frequently when used in salt water.
2. For professional commercial use, log hours of operation to determine proper maintenance intervals.
3. When operating in salt water, turbid or muddy water, the engine should be flushed with clean water after each use.
4. Upon starting, check for unusual engine sounds and cooling water flowing freely from the check hole.
5. When there is 1/3 or more consumption, please exchange.
6. Check the fuel line for leaks, cracks, or damage. If it is leaking, cracked, or damaged, take it to your servicing dealer for
replacement before using your outboard.
7. Check the fuel line for leaks, cracks, or damage. Replace the fuel line if there are signs of leaks, cracks, or damage.
TOOLS
LIST
Engine oil leak Check –
Each operation part Check –
Engine condition (4) Check –
Power trim/tilt Check 3-33
Shift control cable Check-
adjust
3-33
Item REGULAR SERVICE PERIOD (2)
Perform at every indicated month or
operating hour interval, whichever comes first.
Refer
to
page
Each
use
After
use
First
month
or 20
hrs.
Every 6
months
or 100
hrs.
Every
year
or
200
hrs.
Every
2
years
or
400
hrs.
Every
6
years
or
1,200
hrs.
Oil filter wrench, 65 mm
07HAA-PJ70101 or 07AAA-PLCA100
Belt tension gauge
07TGG-001000A or 07JGG-001010A
Valve adjust wrench, 10 mm
07908-5900000
To Next Page
