19-19
dummyheaddummyhead
TRIM/TILT
Position the ground cable [1] against the stopper [2] of
the lower mount center housing [3], and then install and
tighten the screw (6 x 8 mm) [4].
Install the swivel case (page 19-9).
POWER TRIM/TILT DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
• Do not disassemble the pump. If it is faulty, replace it
as an assembly.
• Do not use a shop towel, cloth, or gloves during
removal.
• Use the recommended automatic transmission fluid
(ATF).
Recommended ATF: Honda Genuine Automatic
Transmission Fluid (ATF), DEXRON
®
or equivalent.
• Do not reuse the drained ATF.
• Do not tighten the vise excessively when holding the
power trim/tilt in a vise during operation.
• Clean the removed parts in fresh ATF, and blow
each port of the parts with compressed air. Set the
parts neatly in a suitable container with care not to
contaminate them with dust and dirt.
• Do not reuse O-rings and oil seals.
• Take care not to damage the sliding surface of the
piston rod when removing them.
Remove the power trim/tilt (page 19-6).
Operate the power tilt motor until the each rod reach the
fully extended position (page 19-31).
Remove the oil tank cap [1], and drain the ATF from the
oil tank.
Do not drain the ATF by pushing the piston rod in.
Loosely install the oil tank cap on the oil tank.
To Next Page
