TOHATSU BFT250A - Oil Filler Extension Removal; Installation; Oil Level Gauge Cover Removal; Removal;Installation

12-5
dummyheaddummyhead
LUBRICATION SYSTEM
OIL FILLER EXTENSION REMOVAL/
INSTALLATION
Remove the two bolts (6 x 22 mm) [1] and the oil filler
extension [2].
Apply liquid gasket (Threebond
®
#1141H, Hondabond
HT, Hondabond 4, or equivalent) to the shaded part
shown.
Install the oil filler extension and tighten the two bolts (6
x 22 mm).
OIL LEVEL GAUGE COVER REMOVAL/
INSTALLATION
Remove the R. exhaust manifold (page 5-95).
Remove the oil level gauge.
Remove the four bolts (6 x 18 mm) [1], oil level gauge
cover [2], and O-ring [3].
Install a new O-ring onto the oil level gauge cover.
Install the oil level gauge cover and tighten the four
bolts (6 x 18 mm).
Install the oil level gauge.
Install the R. exhaust manifold (page 5-96).
[1]
[2]
[1]
[2] [3]