TOHATSU BFT250A - Front Separate Cover Removal; Installation; L.;R. Engine under Cover Removal

6-3
dummyheaddummyhead
ENGINE COVER/COVER LOCK
FRONT SEPARATE COVER REMOVAL/
INSTALLATION
Remove the engine cover.
Remove the two bolt/washers (6 x 25 mm) [1], special
bolt (6 x 17 mm) [2], two special bolts (6 x 37 mm) [3],
and remove the front separate cover [4].
Install the front separate cover by sliding the tab [5] into
the engine under cover.
Make sure that under case grommet A [6] is positioned
in the grooves of the engine under cover and front
separate cover.
Loosely tighten the bolt/washer (6 x 25 mm) on the front
side.
Loosely tighten the special bolt (6 x 17 mm) until the
shoulder of the bolt is in the hole of the engine under
cover.
Install and tighten the two special bolts (6 x 37 mm) and
bolt/washer (6 x 25 mm) in the numbered order.
• Keep the remote control cable level.
Tighten the bolt (6 x 25 mm) on the front side and the
special bolt (6 x 17 mm).
Install the engine cover.
L./R. ENGINE UNDER COVER
REMOVAL/INSTALLATION
R. ENGINE UNDER COVER
Remove the front separate cover (page 6-3).
Disconnect the flush plug cap [1] from the R. engine
under cover.
Disconnect the power tilt switch 3P connector [1], and
release the wire from the harness clips [2].
[1]
[5]
[2]
[4]
[1]
5
4
3
[3]
1
2
[6]
[1]
[1]
[2]