TOHATSU BFT250A - Swivel Case;Mount Frame Disassembly;Assembly

19-11
dummyheaddummyhead
TRIM/TILT
Install the anode [1], ground terminal [2] and two bolts
(6 x 23 mm) [4].
If the manual valve [1] is tightened, loosen it fully.
Raise the swivel case a little, unlock the tilt stopper, and
lower the swivel case to the lowermost position.
Install the swivel case/stern bracket to the boat.
Install the mount case (page 18-4).
SWIVEL CASE/MOUNT FRAME
DISASSEMBLY/ASSEMBLY
DISASSEMBLY
Remove the swivel case (page 19-6).
Remove the screw (6 x 8 mm) [1] and ground cable [2].
Remove the external circlip [3].
[1]
[3]
[2]
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
[1]
TO TIGHTEN TO LOOSEN
[1]
[2]
[3]