TOHATSU BFT250A - Page 574

19-12
dummyheaddummyhead
TRIM/TILT
Mark the mount frame [1] so that punch mark [2] aligns
with the " " mark [3] on the lower mount center housing
[4].
Pull the lower mount center housing from the mount
frame using an 8-inch 2-jaw puller (commercially
available) [5] and special tools.
Warm up the lower mount center housing using a heat
gun (ETB1600: commercially available) if it is difficult to
remove.
Wear gloves to protect your hands when handling the
lower mount center housing.
TOOL:
Lower mount puller adapter [6] 07APB-ZY3A200
Puller adapter [7] 07APF-ZY3A200
[5]
[6]
[1]
[7]
[4]
[2][3]
[1]