TOHATSU BFT250A - Page 575

19-13
dummyheaddummyhead
TRIM/TILT
Remove the mount frame [1] from the swivel case [2].
Remove the wave washer (40 mm) [3], oil seal (39.5 x
52 x 6 mm) [4], two swivel case liners [5], and thrust
washer (34 mm) [6] from the swivel case.
Remove the six grease fittings [1] from the swivel case.
Remove the two self-locking nuts [2], two plain washers
(6 mm) [3], two wave washers [4], two plain washers
(12 mm) [5], two thrust receiver bushing B [6], two
thrust receiver bushing A [7], and two thrust receivers
[8].
[1]
[2]
[6]
[5]
[4]
[3]
[5]
[1]
[8]
[7]
[4]
[5]
[2]
[3]
[6]