6-5
dummyheaddummyhead
ENGINE COVER/COVER LOCK
Remove the rivet screw [1] from the L. engine under
cover.
Remove the under cover cap [1] and special bolt [2].
Remove the plug maintenance cover special bolt [3]
and plug maintenance cover [4].
Remove the nine special bolts [5] from the L. engine
under cover [6] and remove it halfway.
Release the under case grommet [7] from the L. engine
under cover.
Remove the trim angle sensor wire [8] and power tilt
motor wire [9] from the hole in the L. engine under
cover.
Installation is in the reverse order of removal.
TORQUE:
PLUG MAINTENANCE COVER SPECIAL BOLT:
10 N·m (1.0 kgf·m, 7 lbf·ft)
[5]
[2]
[1]
[7]
[9]
[8]
[3]
[4]
[6]
To Next Page
