TOHATSU BFT250A - Page 48

2-32
dummyheaddummyhead
SERVICE INFORMATION
L. TIMING BELT BACK COVER
Align the band end of the water
level sensor wire (sensor side)
with the harness clip end.
No.1 FUEL INJECTOR 2P CONNECTOR
WIRE HARNESS CLIP
No.2 FUEL INJECTOR
2P CONNECTOR
No.1 DIRECT
IGNITION COIL
3P CONNECTOR
No.2 DIRECT
IGNITION COIL
3P CONNECTOR
No.3 DIRECT
IGNITION COIL
3P CONNECTOR
WIRE HARNESS CLIP
No.3 FUEL INJECTOR
2P CONNECTOR
FUEL PUMP (HIGH PRESSURE SIDE)
2P CONNECTOR
No.6 FUEL INJECTOR 2P CONNECTOR
WATER LEVEL SENSOR
2P CONNECTOR
HARNESS BAND CLIP
No.6 DIRECT
IGNITION COIL
3P CONNECTOR
No.5 DIRECT
IGNITION COIL
3P CONNECTOR
No.4 DIRECT
IGNITION COIL
3P CONNECTOR
WIRE HARNESS CLIP
No.5 FUEL INJECTOR
2P CONNECTOR
WIRE HARNESS CLIP
No.4 FUEL INJECTOR
2P CONNECTOR
IAT SENSOR 2P CONNECTOR
CMP SENSOR 1
CMP SENSOR 2
4P CONNECTOR
HARNESS BAND CLIP (Cut off the surplus
band leaving approximately 10 mm (0.4 in))