TOHATSU BFT250A - Page 480

16-26
dummyheaddummyhead
GEAR CASE (STANDARD ROTATION)
Set a commercially available universal bearing puller [1]
between the taper bearing (inner race) and the forward
bevel gear.
Drive the taper bearing (60 x 100 x 30 mm) (inner race)
out of the forward bevel gear using the special tools and
a hydraulic press as shown.
Set the bearing race puller (special tool) [1] in the
cutouts [2] in the gear case as shown, and remove the
taper bearing (60 x 100 x 30 mm) (outer race) [3].
Remove the forward bevel gear shim [6] from the gear
case.
TOOLS:
Driver [2] 07749-0010000
Bearing driver attachment,
44 x 49.5 mm [3] 07945-3330300
Pilot, 28 mm [4] 07746-0041100
[2]
[1]
[4]
[3]
TOOLS:
Bearing race puller 070PC-ZY3A101
Remover handle [4] 07936-3710100
Remover weight [5] 07936-371020A or
07936-3710200
[3]
[6]
[1]
[4]
[5]
[2]