TOHATSU BFT250A - Page 486

16-32
dummyheaddummyhead
GEAR CASE (STANDARD ROTATION)
PROPELLER SHAFT HOLDER
DISASSEMBLY/ASSEMBLY
DISASSEMBLY
Remove the needle bearing (32 x 42 x 30 mm) [1] from
the propeller shaft holder [2] using the special tools and
hydraulic press.
ASSEMBLY
Apply gear oil to the circumference of a new needle
bearing.
Drive the needle bearing (32 x 42 x 30 mm) [1] into the
propeller shaft holder [2] using the special tools and a
hydraulic press as shown.
• Install the needle bearing with the stamped end up
(toward the special tool side).
VERTICAL SHAFT DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
Remove the oil slinger [1] from the vertical shaft [2] by
expanding the cut in the oil slinger with a screwdriver.
TOOLS:
Driver, 280 mm [3] 07949-3710001
Oil seal driver attachment,
28 x 35 mm [4] 07945-4150200
Pilot, 32 x 50 mm [5] 07MAD-PR90200
[5]
[2]
[1]
[4]
[3]
TOOLS:
Taper bearing installer
attachment, 90 mm [3] 070PF-ZY3A100
Attachment, 32 x 42 mm [4] 070PD-ZY3A100
[2]
[1]
[3]
[4]
[1]
[2]