TOHATSU EverRun MX 18E2 Service Manual

3-10
Maintenance
2st X18E2 2012
GB
2 Tape 3 Flushing Attachment
11
5) Flushing with Water
WARNING
Be careful not to touch rotating propeller.
Be sure to remove propeller before running
engine on the land.
WARNING
Exhaust gas contains carbon monoxide
which can cause intoxication if inhaled. Do
not operated engine in a closed space such
as interior of boat house.
Flushing using flushing attachment (P/N336-60007-0).
1. Remove the following parts.
● Propeller and thrust holder
1 Water plug.
2. Attach the following parts.
2 Tape:Two locations (on the water strainer)
3 Flushing attachment
● Put water hose from water outlet to 3 and run water.
● Set shift lever to neutral (N) and start engine.
● Check that cooling water check port discharges water,
and run engine for 3 to 5 minutes at idle speed.
● Stop engine and stop water supply, remove 3, attach
and tighten 1, and then, reinstall propeller parts
removed.
Inspection of Water Pump
Refer to Chapter 6.
6) Inspection of Compression Pressure
1. Start and idle engine for 5 minutes to warm up, and then
stop.
2. Shift gear into neutral (N).
3. Remove lock plate (of stop switch lanyard) from stop
switch.
CAUTION
Clean areas around spark plugs on the
cylinder before removing spark plugs to
prevent dirt from entering cylinder.
CAUTION
To prevent accidental start of the engine, remove
lock plate (of stop switch lanyard) from stop switch
before measuring compression pressure.
4. Remove all plug caps 1 and then all spark plugs.
MX18EFSch03120622.qxd12.6.221:52PM  ページ10
2
OIL
WASH
3
1
2
A
B

TOHATSU EverRun MX 18E2 Specifications

General

Brand	TOHATSU
Model	EverRun MX 18E2
Category	Outboard Motor
Language	English