46
9. CONNECTING TO EXTERNAL DEVICES
Set "Comms mode" in the "Comms setup" tab to
"Bluetooth".
• Changing communication settings during
Bluetooth communication will cancel the
connection.
• The status bar icon cannot be tapped in
<Communication Setup>.
• Do not change the setting’ (2) to (7) from the
factory setting, when performing Bluetooth
communication with a recommended data
collector.
• Setting’ (4) to (7) are for an instrument using
GTS commands.
Items set and options (*: Factory setting)
(1) Comms mode : RS232C*/Bluetooth
(2) Check sum : yes/No*
(3) Controller : Remote/2 Way/2
Way+Remote*
(4) REC Type : REC-A *(newly measured
data is output)/REC-B
(displayed data is output)
(5) Terminate
: ETX*/ETX+CR/ETX+CR+LF
(6) Motor State : On (with track state
information)/Off*
(7) Ack mode
:On*/Off
Terminate
Select the option Off or On for carrige return (CR) and line feed when collecting measurement
data with a computer.
ACK mode
When communicating to an external device, the protocol for handshaking can omit the [ACK]
coming from the external device so data is not sent again.
On : Standard
Off : Omit the [ACK]
To Next Page
Loading...
Need help?
General
