9. CONNECTING TO EXTERNAL DEVICES
47
2. Check that "Mode" in the "Bluetooth" tab is set to
"Slave".
• Only "Slave" can be selected when the
instrument is shipped.
3. Set "Authentication" to "Yes" or "No".
If "Authentication" is set to "Yes" for the DS the
passkey will also need to be input on the
companion device.
4. When "Authentication" is set to "Yes", input the
same passkey as that for the intended companion
device. Even if "Authentication" is set to "No", a
passkey is requested when authentication is set
on the companion device being used.
• Up to 16 numeral characters can be input. Input
characters will be displayed as asterisks (e.g.
"*****"). The passkey was set to "0123" at the
factory.
5. Press [OK] to finish settings. Move on to the
Bluetooth communication.
"9.2 Communication between the DS and
Companion Device"
PROCEDURE Registering Bluetooth companion devices used as "Slave"
1. Power on the companion device to be registered.
2. Select "Bluetooth" in "Comms mode".
" PROCEDURE Set Bluetooth
communication mode to "Slave"" Step1
To Next Page
Loading...
Need help?
General
