Preparing the GMS-2 for Use
GMS-2 Operator’s Manual
2-6
to the right to pop it out of the holder. Repeat these steps on the
left side of the holder to remove the coin battery.
5. Insert the new coin battery, plus side up, into the holder. Slide the
coin battery under the tabs and gently push into place.
6. Replace the coin battery cover and screw.
Figure 2-5. Replacing the Coin Battery
Replace the battery within a couple of minutes to
prevent data loss.
GMS-2_OM_Book.book Page 6 Friday, December 28, 2007 1:47 PM
To Next Page
Loading...
