Using the GMS-2
GMS-2 Operator’s Manual
3-6
Surveying with the GMS-2 and an
External Antenna
1. Complete any required pre-survey steps as described in
Chapter 2.
2. Setup the external antenna according to its documentation.
3. Using the external antenna cable, connect the GMS-2 and
external antenna.
4. Open GMS Tools, and tap the GNSS tab.
5. Select External for the antenna setting. Edit the interval and
elevation mask settings as needed.
Figure 3-6. GMS-2 and PG-A5 Antenna Setup
6. Tap Logging.
7. Enter a file name in which to log data, and tap OK to begin
saving position information.
Connect GMS-2 and
External GPS Antenna
GMS-2_OM_Book.book Page 6 Friday, December 28, 2007 1:47 PM
To Next Page
Loading...
