59
TROUBLESHOOTING
Patient ID is required.
Please set patient ID.
Displayed when the output operation is requested when the setting "Patient ID
(Mandatory)" is ON but the patient ID is not inputted. Enter the patient ID and
then request the output operation.
Operator ID is required.
Please set Operator ID.
Displayed when the output operation is requested when the setting "Operator
ID request" is ON but the operator ID is not inputted. Enter the operator ID and
then request the output operation.
Rescan ID. Displayed when barcode reader is connected and the print out button is
pushed without reading the barcode again in the readable state after reading
barcode in the state to be inhibited to read.
If this message is displayed, read the barcode again.
Applying network settings Displayed when applying network setting as "LAN connection" in the "LAN" is
switched to ON or OFF.
Output not set Displayed when all output settings are OFF.
Confirm that the output setting is in the correct way.
Close printer cover The printer cover is open. Close the cover until it clicks.
Paper end Printer paper is used up. Supply printer paper.
Fatal Error! Displayed when the printer unit does not operate normally, such as the cutter
does not work. Call the serviceman.
LAN output... LAN data output is in process.
LAN SUCCESS LAN data output is completed.
LAN hostname error Failed to resolve the host name of the destination (to be connected with the
shared folder). Confirm the inputted host name or DNS server address.
LAN mount Error Failed in connection with the share folder.
Confirm the address, folder name, user name and password of the destination
(to be connected with the share folder).
LAN create Error Failed in file creation.
Confirm that write permission to the share folder is set correctly.
LAN write Error Failed in writing to the file. Confirm that write permission to the share folder is
set correctly. Please check if other program is accessing with the share folder.
LAN start error Failed to reset the LAN connection. Confirm that the LAN cable connection and
the LAN setting are in the correct way.
LAN stop error Failed to reset the LAN connection. Confirm that the LAN cable connection and
the LAN setting are in the correct way.
LAN restruct error Failed to reset the LAN connection. Confirm that the LAN cable connection and
the LAN setting are in the correct way.
DHCP bind error(Timeout) Failed to communicate to DHCP server.
Please contact your network administrator of the facility.
DHCP bind error(NAK) Failed to communicate to DHCP server.
Please contact your network administrator of the facility.
Failed to get IP address. Failed in IP address auto assignment. Set a fixed IP address, or check if the
DHCP server is running.
Please contact your network administrator of the facility.
IP address conflicted Displayed when the IP address is duplicated.
Confirm that the IP address setting of main machine is in the correct way.
Unknown Error Displayed in case of a LAN error other than the LAN errors mentioned previ-
ously. Call your service engineer.
RS-232C DATAOUT RS-232C data output is in process.
RS-232C SUCCESS RS-232C data output is completed.
RS-232C FAIL Failed in RS-232C data transmission.
Confirm that the RS-232C cable connection and the RS-232C setting are in the
correct way.
Range of Input value is 1-10 Displayed when the "Cont. Cycle" is set to a value out of the specified input
range. Enter a value within the input range.
To Next Page
Loading...
