4.1 BEFORE YOU BEGIN
1. Read the packing list to see if there are any items that
have not yet been delivered. We recommend waiting
until you've received all shipments to begin installing the
machine. Depending on the product and options ordered,
the system may arrive in one or more shipments of:
l Accessories(if applicable)
l Machine
Note: The machine system and large
accessories are sent by freight carrier. Smaller
accessories may be sent by parcel service.
2. Inspect the item(s):
l Photograph any damage that may have occurred
during shipping.
l Note any damage on the delivery receipt before
signing for the shipment.
l Verify the received goods against the packing list.
If there is any damage or shortages, you must contact
Tormach within 30 days of receipt. Email
support@tormach.com to contact Tormach Technical
Support for guidance on how to proceed.
4.2 INSTALLATION TOOLS AND ITEMS
Before uncrating and installing your machine, collect the
following tools and items.
l 19 mm socket wrench
l Cardboard piece, large
l Carpenter's level
l Dead-blow hammer (or similar)
l 500-lb capacity engine hoist
l Lifting straps
l Metric hex wrench set
l Pallet jack
l Phillips screwdriver
l Safety eyewear that meets ANSI Z87+
l Snips
l Wood blocks
l Work gloves
4.3 MOVE THE PALLET
Tools and Items Required
l Pallet jack
Shipments arrive in crates loaded on standard pallets, which
the freight carrier unloads onto the curb or loading dock.
WARNING! Transportation and Lift Hazard: Before
moving the machine, you must confirm that all
persons are clear of the area below the machine.
Qualified professionals must transport, lift, and move
the machine. Moving parts can entangle, pinch, or cut
you, causing death or serious injury.
Verify that the ground surface is smooth, and then use a
pallet jack to move the pallet(s) to the desired
installation location.
Note: If the ground is not smooth, you may
need to use a forklift (or similar lifting
equipment rated for uneven surfaces) to move
the pallet(s).
4.4 ASSEMBLE THE MACHINE STAND
Tools and Items Required
l 19 mm socket wrench
l Cardboard piece, large
l Phillips screwdriver
l Safety eyewear that meets ANSI Z87+
l Work gloves
CAUTION! Sharp Objects Hazard: Before opening the
shipping crate, you must put on work gloves and
safety eyewear that meets ANSI Z87+. If you don't,
the shipping crate and steel straps could cut you,
causing serious injury.
©Tormach® 2021
Specifications subject to change without notice.
Page 24 UM10753: 8L Operator's Manual (Version 0321B)
For the most recent version, see tormach.com/support
4: INSTALLATION
To Next Page
Loading...