Toro 04042 - EZ Turn Sensor

EZTurnSensor
g202573
Figure108
1.EZturnsensor4.Targetplate
2.SensorLEDlocation
5.1.5inchblockunderroller
3.Sensorbracket6.Cuttingunitrollframe
TheEZturnsensorisanormallyopenproximitysensorthatmountstoasensor
bracketmountedtothecuttingunitrollframe(Figure108).Thesensingplatefor
thesensorisatargetplateattachedtothetopofthecuttingunitassembly.The
TECmonitorstheoperationoftheEZturnsensor.
Whenthetractionunitissupportedonthetractiondrumwiththecuttingunit
supportedbybothfrontandrearrollersonlevelground,thetargetendoftheEZ
turnsensorispositionedawayfromthetargetplateonthecuttingunitsothatthe
sensorisopen.TheEZturnsensorismovedtowardthecuttingunittargetplate
whenthecuttingunitisraisedforturning,causingthesensortoclose.
Note:TheEZturnsensorLEDshouldbeilluminatedwheneverthemachineis
operational(thekeyswitchintheRUNposition)andthecuttingunitisraised.
Note:TheEZTurnfunctionisonlyactivewhenthemachineisbeingoperated
withthecuttingunitengaged.Also,theEZturnswitchandEZturnsensorarein
seriessobothswitchandsensorhavetobeONfortheEZTurnfunctiontobe
ON.IfeithertheswitchorthesensorisOFF,theEZTurnfunctionwillbeOFF.
Note:TheinformationonEZturnsensoradjustmentisincludedintheeFlex
Operator’sManual.
TestingtheSensor
1.Parkthemachineonalevelsurfaceandplacethetractionleverinthe
NEUTRALposition.
2.TurnthekeyswitchtotheSTARTpositiontowakeupthemachineandthen
turnthekeyswitchtotheRUNposition.
3.ChecktheLEDonthecableendoftheEZturnsensor:
A.ThesensorLEDshouldnotbeilluminatedwhenthecuttingunitisbeing
supportedbybothfrontandrearrollersonlevelground.
B.ThesensorLEDshouldbeilluminatedwhenthecuttingunitisraised
(handlepusheddown).
ElectricalSystem:TestingtheElectricalComponents
Page5–58
Greensmaster
®
eFlex1800,2100and2120
12189SLRevE